Find or Sell Used Cars, Trucks, and SUVs in USA

1967 Chevy Truck, Shortbed, Custom Truck, Air Ride, Chopped 3" on 2040-cars

US $17,500.00
Year:1967 Mileage:0
Location:

Norwalk, Iowa, United States

Norwalk, Iowa, United States
Transmission:Automatic
Vehicle Title:Clear
Engine:built 350
Fuel Type:Gasoline
For Sale By:Private Seller
VIN: CE147S155336 Year: 1967
Number of Cylinders: 8
Make: Chevrolet
Model: C-10
Warranty: Vehicle does NOT have an existing warranty
Trim: c-10
Power Options: Power Windows
Drive Type: 2wd
Mileage: 0
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

This is a 1967 chevy truck that is an extreme custom. This truck has been customized in every way, i own my own shop and have no time to finish this truck, customers come first. would not take much to finish. This truck does run and drive. Lets start off with it has a built 350 motor all gone through freshly rebuilt motor with all the good stuff and chromed out. 350 turbo transmission rebuilt. This truck has a 3 inch chop, tunnel between the seats for the drive shaft and a custom interior with a 1960 dash installed. This truck does not have any fiberglass work to it it is all metal. I have the bucket seats that fit in it that we wrapped the back side of the cab around. It has a smoothed out firewall and a 1 piece front end that we welded the fenders to the grill and inner fenders. The front grill has been modified which you can see in the pics and i have the headlights for it to. The bed is a one piece bed that has the floor raised in it and a cut out for the c-notch. This truck is on air suspension to where the truck will sit on the ground and raise 12 inches. It is all tubular front and rear with a rack and pinion front and 4 link rear with 3.73 gears. Everything has been powdercoated and all stainless steel hardware used throughout the truck. The wheels and tires in the picture do not come with it but it does have tires on it to move it. There really is to much to add, but there is not another truck out there like this one. so call if interested, i have about 35,000 in this truck so my loss your gain. Asking $17,500 , you can call us at 515-371-4782 with any question. I HAVE ALOT MORE PICS OF THE TRUCK FROM START TO WHERE IT IS NOW, .

Auto Services in Iowa

Trail`s End Auto and Truck Salvage ★★★★★

Automobile Parts & Supplies, Used & Rebuilt Auto Parts, Automobile Salvage
Address: 1600 NE 44th Ave, Berwick
Phone: (866) 595-6470

Shaffer`s Auto Body Co. Inc ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Brake Repair
Address: 1712 E Lincoln Way, Huxley
Phone: (515) 509-2535

Schuling Hitch Company ★★★★★

Automobile Parts & Supplies, Trailer Hitches, Automobile Accessories
Address: 5067 NW 2nd St, West-Des-Moines
Phone: (866) 595-6470

Quality Car Care ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Inspection Stations & Services
Address: 900 Highway 965 NE Unit #6, Oakdale
Phone: (319) 626-2500

Phillip`s Auto Clinic ★★★★★

Auto Repair & Service, Tire Dealers
Address: 200 S Jefferson St, Mount-Pleasant
Phone: (319) 385-2769

Orlando`s Automotive ★★★★★

Auto Repair & Service
Address: 5245 NW Beaver Dr # B, Johnston
Phone: (515) 331-1922

Auto blog

Camaro spy shots show subtly different grille, front fascia

Sun, 03 Feb 2013

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

2014 Chevrolet Silverado and GMC Sierra show all their sides in Detroit

Tue, 15 Jan 2013

There could hardly be more riding on the next-generation General Motors full-size pickup trucks, so the automaker has wisely made sure to have a selection of different models on hand at the Detroit Auto Show to show off. The 2014 Chevrolet Silverado and 2014 GMC Sierra were both officially introduced last month at a stand-alone reveal, and now they'll be on display for the public to see in various body configurations and trim levels.
The Silverado LTZ Crew Cab and Sierra SLE Extended Cab are aimed at providing more of a high-end pickup experience, while the Silverado LT Z71 Extended Cab and Sierra SLT Z71 Crew Cab should have off-road fans scouting out their favorite trails. The crew cab trucks won't go into production until sometime during the second quarter of this year - with other bodystyles coming later in the year - but we have plenty of live images from Detroit for you to enjoy.

GM recalling over 243,000 crossovers over possible seat belt defect

Tue, 17 Aug 2010

2010 Buick Enclave - Click above for high-res image gallery
The summer of 2010's recall hit parade continues unabated today, with General Motors having just announced that it is asking 243,403 owners of its 2009-2010 Lambda crossovers to bring their three-row haulers in for inspection. The culprit? Second-row seat belts in select Buick Enclave, Chevrolet Traverse, GMC Acadia, and Saturn Outlook CUVs have "failed to perform properly in a crash."
According to GM, a second-row seat-side trim piece is to blame, as it can impede the upward rotation of the buckle after the seat is folded flat. As a result, if the buckle makes contact with the seat frame, cosmetic damage can occur, potentially requiring additional force to operate the buckle properly. So far, no great shakes, but in the process of applying that additional force, the occupant may push the buckle cover down to the strap, potentially revealing and depressing the red release button. As a result of this, the belt may not latch, or in certain cases, it may actually appear to be latched when, in fact, it isn't.