1980 Chevrolet El Camino 5.0l Project on 2040-cars
Liberty Hill, Texas, United States
Body Type:Standard Cab Pickup
Engine:5.0L 305Cu. In. V8 GAS OHV Naturally Aspirated
Vehicle Title:Clear
Fuel Type:GAS
For Sale By:Private Seller
Interior Color: Tan
Make: Chevrolet
Number of Cylinders: 8
Model: El Camino
Trim: Base Standard Cab Pickup 2-Door
Drive Type: RWD
Power Options: Air Conditioning
Mileage: 97,742
Exterior Color: White
High I got this El Camino to restore but it needs just to much work for the way I want it. it has a 305 v8 engine with the automatic transmission. the interior has been stripped partially, I have put in a pair of bucket seats from a 1991 firebird I still have the original split bench seat. it has a few small rust pin holes in the floor, it could use a paint job. the engine runs but needs a oil change. the carburetor needs work, it is not the original carb but a older replacement Edelbrock. The hood is off right now but will be put back on shortly. I understand that it needs work. payment will be in cash and I will accept a down payment through pay pal. will not deliver or ship, local pick up only.
|
Chevrolet El Camino for Sale
- 1960 el camino
- 1970 chevrolet el camino ss 396, 4 speed, matching numbers, body off restoration
- El camino project cars (2)cars conquista, limited edition chevy 2 titles !!!!!
- Time capsule- original 1974 el camino - 12,800 miles(US $15,000.00)
- 1966 chevrolet el camino base standard cab pickup 2-door 4.6l
- 1964 elky 350, brand new a/c cold, showroom condition, perfect 350, automatic
Auto Services in Texas
Yale Auto ★★★★★
World Car Mazda Service ★★★★★
Wilson`s Automotive ★★★★★
Whitakers Auto Body & Paint ★★★★★
Wetzel`s Automotive ★★★★★
Wetmore Master Lube Exp Inc ★★★★★
Auto blog
GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch
Mon, 04 Feb 2013According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.
GM recalling nearly 4,000 vehicles over airbag concerns
Thu, 31 Jan 2013Four different General Motors vehicles from the 2012 model year are being recalled over a potential airbag issue. The driver's side airbag shorting bar in the 2012 Buick Verano and 2012 Chevrolet Camaro, Cruze and Sonic might make contact with the airbag terminals, even during a crash. If so, the airbag won't deploy when it should, possibly increasing injury to the driver.
The recall is expected to begin on February 13 for the 3,896 units that might be affected. GM will notify owners who can then take their vehicles to dealers to have the airbag coil replaced. A bulletin from the National Highway Traffic Safety Administration below has more info.
Why does the Corvette Stingray have so many vents? Here's why
Sun, 27 Jan 2013Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.
2040Cars.com © 2012-2024. All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.
Use of this Web site constitutes acceptance of the 2040Cars User Agreement and Privacy Policy.
0.017 s, 7231 u