Find or Sell Used Cars, Trucks, and SUVs in USA

1966 Chevelle 2dr Coupe on 2040-cars

Year:1966 Mileage:1
Location:

Fredericktown, Missouri, United States

Fredericktown, Missouri, United States

1966 Chevelle 2 door coupe

BODY
New 1 piece floor pan
New 1 piece trunck
New tail panel
New full quarter panels
New rear inner and outer rear wheel housings
New rear deck filler panel
New rocker panels
New lower windshield panel (needs to be welded)
New radiator core support
New upper and lower door hinges
New front and rear bumpers, along with original front and rear bumpers
New gas tank
New front inner fender wells
New body bolt kit

Trunk lid is original
Doors are original
Hood is original

Front fenders are not included

When the car was purchased the original drip rails had been removed to try and make a smooth roof line  The drip rails have since been added back, however to make this look right, a new roof would be required. (Reproduction roofs are available now).  The current roof is only tacked in place and is easily removed.

The firewall has been removed due to the lower floor pans being rusted out, and a poor attempted to smooth the firewall.  A new firewall will be required to complete this car.  (Reproduction firewalls are available now).

All of the side glass, and rear window are usable, but do show signs of scratches from over the years.  There is no windshield included.

The car was completely dissassembled and media blasted prior to installing the new body panels.

CHASSIS
The frame was sandblasted and has been powered coated a dark gray.
Energy suspension bushing have been installed in the upper and lower control arms.
A Hotchkis total vehicle system suspension kit has been installed.
An Eaton posi unit has been installed in the rear end.
New front rotors, wheel bearings and calipers.
New inner and outer tie rod ends.

ENGINE
The car was an original 283, with a 3 speed transmission(Transmission is not included).
The 283 engine has been disassembled, but everything is available, with the exception of the lifters, push rods, intake manifold and carburetor.  The block looks to be in good condition, just needs to be cleaned up and rebuilt.

Also included will be a standard bore 350 4 bolt main block
New C.A.T lightened 4340 forged crank
New C.A.T 4340 6” rods

MISCELLANEOUS
The front and rear bench seats frames will be included, but most of the interior was discarded as it had been badly abused over the years.

Most pieces of the car were kept when it was disassembled, however depending on the level of restoration they may or may not be useable.

Buyer is responsible for vehicle pickup, no shipping.

Auto Services in Missouri

Value Auto Clinic ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Electric Service
Address: 2819 Gillham Rd, Pleasant-Valley
Phone: (816) 931-5100

The Car ★★★★★

Used Car Dealers, Wholesale Used Car Dealers
Address: 3107 E Chestnut Expy, Fordland
Phone: (417) 865-2500

Ted`s Automotive ★★★★★

Auto Repair & Service, Automobile Air Conditioning Equipment
Address: 405 SE 10th St, Napoleon
Phone: (816) 690-7268

Swafford`s Auto Service ★★★★★

Auto Repair & Service, Gas Stations, Brake Repair
Address: 1319 N Westwood Blvd, Poplar-Bluff
Phone: (573) 686-4243

Strosnider Enterprises ★★★★★

Auto Repair & Service
Address: 3355 E Terra Ln, Old-Monroe
Phone: (866) 595-6470

St. Louis Window Tinting ★★★★★

Auto Repair & Service, Window Tinting, Glass Coating & Tinting
Address: 128 Long Rd, Chesterfield
Phone: (314) 485-4157

Auto blog

Chevrolet Camaros at SEMA are a mobile accessory catalog

Wed, 06 Nov 2013

Chevy's goal at the SEMA Show in Las Vegas this week seems to be to show as much of its Performance and Accessories catalog as possible. That's why it brought three different Camaros - two with V8s and one powered by a V6 - with all of the best goodies from the catalog already fitted.
We gave a more in-depth recap of the Performance Camaro V8 Concept, the Performance Camaro V6 Concept and the Performance Garage Concept already, but we figured you'd like a short recap for each. It should be noted, though, that you can order all of the items you see here for your own Camaro, so be sure to take a long, hard look at our live galleries, just in case you're in the market for some mods.
Essentially, the Performance Garage Concept and the Performance V8 Concept are the same car - the only difference is that the later features a whole host of aesthetic tweaks in addition to its aftermarket, shorty exhaust headers and 2.75-inch exhaust. (The Performance Garage Concept has been usefully placed on its side; the better to see the new parts added to the vehicle.) The Performance V6 Concept is notable because, despite being a V6, there's no shortage of performance goodies fitted. All three of the Performance Camaros benefit from items from the Camaro ZL1, which can also be ordered through the catalog.

2015 Chevrolet Cruze spied on its home turf

Tue, 23 Apr 2013

The next Chevrolet Cruze isn't set to go into production for about another year, and we're just now seeing prototypes of the new compact running around here in the States. Not much more has been revealed since we saw the car blasting through the snow in Europe, but we can still clearly see new design elements like the larger grille, slimmer headlamps and redesigned taillamps.
Our spy photographers worked up a composite image of this Cruze prototype alongside the current model, and here, we can clearly see some big visual changes are in store for the new model. The 2015 Cruze's hood slopes downward more dramatically, the windshield is more heavily raked, and the roofline looks more fluid overall. The next-generation Cruze will ride on the new global Delta platform that will also underpin other General Motors vehicles like the Chevrolet Volt and Equinox.
As for what's under the hood, we expect the normal range of gasoline four-cylinder engines (both naturally aspirated and turbocharged), and the compact's new turbodiesel four should carry over, as well. Have a look at the full brace of spy photos in the gallery above.

Chevy exec confirms SS production model reveal at Daytona on Feb 16

Wed, 06 Feb 2013

The 2014 Chevrolet SS will make its racing debut for the 2013 Daytona 500, but the production version of the car will get its official unveiling on February 16 in Daytona, a week before The Great American Race. According to a report by Automotive News, the reveal has been confirmed by Jim Campbell, Chevy's US vice president of performance and motorsports. With the departure of the Dodge Charger, the new Chevrolet racecar will be the only competitor to feature a V8, rear-wheel-drive layout in both street and NASCAR form.
NASCAR fans will be able to see the new fullsize performance-oriented sedan on display in the festivities leading up to the Daytona 500, but the car won't go on sale until later in the year. The Australian-built Chevy SS will be a low-volume performance model, and it will be priced above the 2014 Impala, which starts at $27,535.