Find or Sell Used Cars, Trucks, and SUVs in USA

1953 Chevrolet 3100 5 Window Truck Pickup Rat Rod on 2040-cars

US $23,500.00
Year:1953 Mileage:300
Location:

Marion, Ohio, United States

Marion, Ohio, United States

 Thank you for looking at my auction! Up for sale is a well built 1953 Chevrolet 5 Window Pickup. The truck was built by our shop in Marion, Oh called Poor Boys Resto. You can check us out on facebook. We are a local shop who builds hot rods and customs, does full restorations, and Custom race car work. We have an owned an operated Top Sportsman drag racing team, and bring to the table 40 years of combined experience between my father and I. This truck was a project that we built to keep as our own shop truck. Looking to put more money into our car as the season draws mid-way. So the truck is up for Sale As-is. The best components and the utmost attention to detail were mandatory on this vehicle. The details on the build are below. Any questions please do not hesitate to call me at 740-262-3732

Engine- 5.3l Ls, New wires, plugs, wire heat boots, starter, and alternator. Engine and alternator was mounted using Dirty Dingo slider mounts and the Alt only set up. 60,000 MILES!!!

Trans- 4l60E, 30" Lokar Trans mounted shifter. 

Drive TrainNew balanced custom driveshaft with new yoke and U-Joints built by Driveline 1 out of Columbus, OH. 75' Camaro GM 10 bolt 8.5 Rear end, Non-Posi, Drum Brakes.

Chassis- Factory chassis retained. Mustang II front suspension out of a mid 70's mustang. Front big disc brake kit. 11.5" drilled and slotted rotors with GM metric calipers.  Chassis was POR-15 painted. Boxed in the front where the IFS was installed. Brake lines are all stainless steel other than the tough bends and those are the NiCopp line. New chassis mounted power brake booster and master cylinder. Has a MANUAL mustang II rack. New Borgeson joints and stainless steel shaft were used as connections. Jegs 20 circuit wiring harness powers the chassis and inner cab. All lights are functional and new.
Truck Sits where it does because I like to drive things and not avoid railroad tracks or high bumps.  It lays running boards out in the grass and sits about 2" off the ground otherwise. Truck was built for functionality not to be a trailer queen. If that's the route you want to go you can adjust the front bag cups, and i will include a rear step notch kit, made for this frame from Gambino customs bought here on ebay.

Exhaust
- Hooker Block Hugger Headers, 2.25 single Custom built exhaust with a Flowmaster 40 Series muffler.

Air-Ride- The Air-Ride System is 100% RideTech other than the rear bags and mounts. Installed the RideTech front mustang II bag brackets, bags, and shock kit. Has the upgraded kit that comes with a larger rear tank, 2 compressors, and the red billet valve assembly which is mounted behind the seat. The rear set up is Slam Specialties 7" bags for a much nicer ride, paired up with Thor Brothers brackets.

Fuel System- Tanks Inc fuel injection tank. Bought the pump that is capable of handling 600hp. (We were going to run turbos on it.) The fuel System is 100% 6an braided line. Has the Corvette regulator system which is the return/filter/regulator all in one little tube.

InteriorThe dash was painted black with the polished glove box and radio cover. Factory re-covered and Fully re-built seat. All factory trim is in place and functional. It still needs carpeted, gauges, and the door glass put in. *You must purchase glass* Used the truck on nice days so never worried about it. Has a new chrome tilt column, a a new grant steering wheel. The turn signal and hazards are built into the column. Has factory door panels that i have not installed. Truck comes with another set of door that have all door and inner workings in it. You will need DOOR GLASS. All other glass in the truck was replaced with new seals.

Exterior- The truck was painted about 20 years and shows it with the beautiful patina it has. Has some bondo in the lower rear fenders, and front lower front fenders. That tail gate has quite a bit of bondo too. Not because of rust but i think because they were trying to smooth the lines out. The cab was purchased from kansas and has a few dents but ABSOLUTELY ZERO RUST. Bought a fulton visor to go along with it. Bed is not finished in the pictures but will be by auction end. Its getting red-oak to enclose the tank and Air-ride. There is absolutely zero room to work with using the factory chassis so instead of raising the bed floor 6-8 inches like an s-10 build i placed the tank near the cab for easy fill-ups and you will still have 4 1/2 foot of whole depth bed to use for parts, chairs, coolers, and etc.. You will have 8 bolts to take out for any air-ride service or fuel system problems. *Keeping it functional* especially for those without a lift.

Wheels- Wheels are Boss 338 18x8 front and 18x9.5 rear. These are wrapped in new Nitto Neo Gen tires. Rears have a nice dish to them and give it that hot rod look.




                           




On Jun-24-14 at 04:55:31 PDT, seller added the following information:

 I would do some trading on a 1967-1969 Camaro, or a 1967-1973 firebird. Thanks!

Auto Services in Ohio

Whitesel Body Shop ★★★★★

Automobile Body Repairing & Painting, Truck Body Repair & Painting
Address: 3646 N County Road 605, Dayton
Phone: (740) 965-5758

Walker`s Transmission Service ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 486 US Route 68 S, Riverside
Phone: (937) 372-6350

Uncle Sam`s Auto Center ★★★★★

Auto Repair & Service, Tire Dealers
Address: 4253 Lewis Ave, Oregon
Phone: (419) 806-0854

Trinity Automotive ★★★★★

Auto Repair & Service, Tire Dealers
Address: 29 W Xenia Ave, Jeffersonville
Phone: (937) 766-9772

Trails West Custom Truck 4x4 Super Center ★★★★★

Automobile Parts & Supplies, Truck Equipment & Parts, Trailer Hitches
Address: 12290 National Rd SW, Sunbury
Phone: (866) 595-6470

Stone`s Auto Service Inc ★★★★★

Auto Repair & Service
Address: 350 N Main St, Springboro
Phone: (937) 866-3674

Auto blog

Chevy gets cracking on Cruze EV fleet testing

Tue, 21 Sep 2010

Chevrolet Cruze EV - Click above for high-res image gallery
The Chevrolet Volt hasn't yet gone on sale, but General Motors is looking at ways of expanding its electric vehicle lineup. Chevy, along with partner LG, is employing a group of all-electric cars in the form of the Cruze. The sedans are part of a demonstration fleet which is located in Seoul, South Korea and is being used to provide data in an electric vehicle research project. The goal is to gather information on driving patterns and charging behavior in addition to consumer acceptance.
The Cruze EVs, along with some Daewoo Lacetti Premieres EVs, are the first fleet of full-size electric vehicles and should provide invaluable information for The General. Staying full-size means not sacrificing cargo space, so the battery pack is mounted to the underbody, leaving the trunk area open for plenty recyclable, canvas grocery bags.

GM applies for LT5, LTX trademarks... are new small block variants coming?

Mon, 29 Apr 2013

Recently discovered General Motors trademark applications for LT4, LT5, LT88 and LTX have observers wondering what kind of high-performance offerings could be on their way. A new LT4 would mark a return of the engine designation first used on the Corvette Grand Sport, SLP Pontiac Firehawk and SLP Chevrolet Camaro SS from 1996 and 1997. Supposition at Corvette Forum - which provided advance intel on the C7 like these leaked images - believes a new LT4 could go into the high-performance trim of the next-gen, 2015 Camaro that would be more powerful than the 580-horsepower Camaro ZL1.
Seeing an LT5 again would also be déjà vu - in its former life it was a 5.7-liter V8 for the C4 Corvette ZR-1 from 1990-1994 designed by Lotus, producing from 370 hp to 405 hp. A mix of rumor and hope is that the new LT5 will be a supercharged evolution of the 6.2-liter LT1 (pictured) placed in the new C7 Corvette, and that it will go into the C7 version of the ZR1 pumping out something like 700 hp.
The LTX trademark is, as with that last letter, a complete mystery. If the "X" isn't a generic way to denote the whole LT family, it's wondered if it LTX could refer to a crate motor offering like the LSX.

800k car names trademarked globally, suddenly alphanumerics seem reasonable

Tue, 01 Oct 2013

What's in a name? This cliched phrase probably gets tossed out at every marketing meeting that happens when a new car gets its nomenclature. We know the answer, though: everything. The name of a car has all the potential to make or break it with fickle customers that are more conscious than ever about what their purchases say about them.
That's giving headaches to marketing folks across the automotive industry. "It's tough. In 1985 there were about 75,000 names trademarked in the automotive space. Today there are 800,000," Chevrolet's head of marketing, Russ Clark, told Automotive News. Infiniti's president, Johan de Nysschen, echoed Clark's sentiment, saying, "The truth of the matter is, across the world, there is hardly a name or a letter that hasn't already been claimed by one car manufacturer or another. You can go through the alphabet - A, B, C and so forth - and you will quickly see that almost all available letters are taken."
What has that left automakers to do? Get creative. In the case of Infiniti, it made the controversial move to bring all of its cars' names into a new scheme, classifying them as Q#0 for cars and QX#0 for SUVs and crossovers. So the Infiniti G, which was available as the G25 and G37, is now the Q50. The FX37 and FX50 are now the QX70.