2006 Chrysler Sebring Gtc Convertible 2-door 2.7l on 2040-cars

Auto blog

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.

Mopar opening Custom Shop at Cobo

While other automakers have been streamlining their brand portfolio, the Chrysler Group has shown no such signs. It's got the Dodge, Chrysler and Jeep brands, plus Fiat, and it recently broke out its SRT and Ram nameplates into their own brands. And you can bet each will have its own presence at the Detroit Auto Show this year. But don't forget Mopar. The company's performance parts division is getting its own display at Cobo this year, and it'll be the largest in the brand's history.
The Mopar Custom Shop is poised to take up 5,500 square-feet of Cobo floor space, further expanding on last year's Mopar Garage. If the image above offers any indication, the show stand will include a Dodge Challenger, SRT Viper, Fiat 500L, Jeep Wrangler, Jeep Cherokee, Ram 3500 and what looks like (but isn't identified in the press release below as) a Chrysler 200 (which may be replaced by a 2014 model), all augmented with Mopar parts and accessories.
Visitors will also be able to use pre-programmed iPads to configure Chrysler Group vehicles with a wide range of accessories - a portfolio that grows by 1,500 new parts every year and tops over 100 add-ons for every new vehicle Chrysler launches.

Chrysler recalls 1.2 million Ram pickup trucks

Chrysler has announced that it will issue three separate recalls that will cover as many as 1.2 million Ram pickup trucks for "steering-system tie rods that may have been misaligned during assembly or steering-system service." The vast majority of these trucks were sold in the United States, though some trucks in Mexico, Canada or overseas will be called in, as well.
The largest of the three recalls covers an estimated 842,400 model-year 2003-2008 Ram 2500 and 3500 trucks. Two smaller campaigns will bring 294,000 model-year 2008-2012 Ram 2500 and 3500 pickups, chassis cabs and 2008 Ram 1500 4x4 Mega Cabs; plus 43,500 model-year 2008-2012 Ram 4500 and 5500 4x4 chassis cabs into the dealer to be checked and repaired if necessary.
This is a very large recall, and Chrysler says it is "casting the net wider than necessary to identify those vehicles that require repair." The automaker estimates that "as many as 726,000 may not need repair."