Find or Sell Used Cars, Trucks, and SUVs in USA

1970 Challenger 440 on 2040-cars

Year:1970 Mileage:146334 Color: Primer /
 Black
Location:

Red Bud, Illinois, United States

Red Bud, Illinois, United States
Transmission:Automatic
Body Type:Coupe
Engine:440
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
VIN: JH23G0B119908 Year: 1970
Number of Cylinders: 8
Model: Challenger
Trim: Base Coupe 2 Dr
Drive Type: RWD
Power Options: Air Conditioning
Mileage: 146,334
Exterior Color: Primer
Interior Color: Black
Warranty: Vehicle does NOT have an existing warranty
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

Originally 318 car.  Now has rebuilt 440 and rebuilt 727TF transmission.  This is not a gunked up junkyard smog motor.  It came out of a 1967 Imperial with stock 10.10 to 1 compression and forged crank. This 440 has been completely rebuilt and rotating assembly balanced with .040 over forged pistons, reconditioned rods, Mopar Performance Purple Camshaft Kit, valves, guides, valve springs, hardened pushrods, adjustable rocker arms, high volume oil pump with new pickup, clevite bearings, roller timing chain, Mopar Performance oil pump drive shaft and distributor gear, Mallory Unilite ignition and wires, TCI SFI 29.1 approved flex plate, TCI Torque converter, Holley 4bbl carb (not new but rebuilt) and headers.  The car has never been driven with the new engine and trans but it gets started and run through the gears on jack stands every 30 days or so and the oil and filter are changed every 8 months.


The car has had the following sheet metal replaced: floors, trunk pan, front valance, rear valance and rear window to deck lid panel.  The original driver's door had a dent and body filler in it so it's been replaced by a good used one.  The original door is fixable and goes with the car.  The floors beneath the rear seats still need repaired as seen in the pics.  The firewall has a rust hole in it too.  Front drum brakes have been changed to disk with all new ball joints and bushings.  The original drum assemblies (spindles, control arms, etc) go with the car as well. The driver's side fender is rusted though at the bottom behind the front wheel, the passenger quarter panel is beat up pretty bad on the rear corner by taillight.  Looks like it was dented and someone tried to pull the dent out.  The windshield is cracked but the rest of the glass is good.  The quarter windows have some scuffs and scratches so I picked up another set at a swap meet years ago and they go too.  The passenger taillight lens is broken but I have an extra complete set of good taillight assemblies that go with the car.  Same goes for the dash, the original one (with the VIN tag) is severely cracked but there is another one in good shape that goes with the car.  See the pics of all the parts.

I think most of the parts are there (except gas tank) to put the car back together....and some extra parts too, including a new set of frame ties.  I tried to take pictures of everything but please ask questions if you want to know something. 

I have a video of the engine running.  If you'd like to see and hear it, copy and paste this into your browser:   http://youtu.be/51C9Jq6gfpw

I WILL NOT SELL INDIVIDUAL PARTS SO DON'T ASK.  EVERYTHING GOES TOGETHER OR NOT AT ALL. I've had this car for 15 years but there never is enough time or money to finish it so it's time to go.  There is no "buy it now" so please don't ask.  

Sold AS IS/WHERE IS.  It runs and moves on it's own power so can be driven onto a trailer.  If you bring a check for payment, don't expect to take the car home or get the title signed over until it clears the bank.  This goes for bank checks too.  Lots of fake "Cashier's" checks today.


Auto Services in Illinois

Vega Auto Repair ★★★★★

Auto Repair & Service
Address: 1313 E Cass St, Rockdale
Phone: (815) 727-1680

Ultimate Deals Vehicle Sales ★★★★★

Used Car Dealers
Address: 24237 W Riverside Dr, Wilmington
Phone: (815) 255-2147

Tredup`s Inc ★★★★★

Automobile Body Repairing & Painting
Address: 230 E State St, Burlington
Phone: (847) 695-6300

Terry`s Service ★★★★★

Auto Repair & Service
Address: 10525 S Maplewood Ave, Chicago-Ridge
Phone: (773) 445-2767

Stan`s Repair Service ★★★★★

Auto Repair & Service, Automobile Repairing & Service Facilities-Renting
Address: 2424 W Rohmann Ave, Pekin
Phone: (309) 676-0177

St Louis Dent Company ★★★★★

Auto Repair & Service, Dent Removal
Address: 9849 Manchester Rd, Cahokia
Phone: (314) 809-3368

Auto blog

Lackluster Dodge Dart sales trigger layoffs

Thu, 06 Mar 2014

Hidden amidst the overall very positive sales figures that Chrysler released earlier this week were a few disappointments, the biggest of which may be the Dodge Dart. While Dodge sales in general were down 11 percent from a year ago, the Dart's poor figures stood out from the rest - with 4,888 units sold, the Dart was down 37 percent in February.
It comes as little surprise, then, that the automaker has announced layoffs at its assembly plant in Belvidere, IL. According to The Daily Herald, Dodge will temporarily lay off 325 workers "to balance vehicle supply with current sales demand." Put more simply, there are more Darts than buyers at the moment...
We don't think the Dodge Dart is a bad car, but it's playing in a market that offers a few standout sellers, like the Chevy Cruze, Ford Focus, Honda Civic and Toyota Corolla. According to AutoPacific analyst Dave Sullivan, as quoted by The Daily Herald, "great incentives on the Dodge Avenger" are also partly to blame for the Dart's poor showing.

Chrysler almost smothered the Hellcat before it lived

Thu, 06 Nov 2014

Chrysler's 6.2-liter supercharged Hellcat V8 was an absolute sensation from the very moment it was announced, and honestly, how could it not have been? Packing 707 horsepower and 650 pound-feet of torque, its numbers immediately put every other production muscle car (and many supercars) to shame. Plus, we soon learned that would be wrapped in a package retailing for around $60,000 - a pittance compared to other vehicles offering similar grunt. However, the Hellcat almost never got the chance to rumble under the hood of the Challenger and Charger.
The Hellcat was initially proposed back in 2011, back when Fiat was deciding its future strategy for Chrysler Group, according to Automotive News. At the time, the company was just emerging from its bankruptcy doldrums, and an ultra-high-performance V8 wasn't exactly a must-have item. The program didn't move forward. However, SRT engineers kept fighting, according to AN, and four months later, they received the green light to pull the project off the shelf and continue developing the Hellcat. The muscle car world is certainly better for that decision.
The work of those engineers focused on taking Chrysler's standard 6.2-liter V8 and making it reliably handle all of the extra power from the supercharger. "It came down to micron levels of changes in the crank to be able to withstand the pressures of the engine," said Chris Cowland, director of advanced and SRT powertrain, to Automotive News. The changes amounted to switching out about 91 percent of the parts to make the Hellcat, including some quite minuscule alterations. For example, the washer holding the supercharger pulley is embedded with industrial diamonds to keep it from slipping.

Dodge Viper recall requires small-handed mechanics

Fri, 25 Apr 2014

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.