Find or Sell Used Cars, Trucks, and SUVs in USA

1964 D 100 Short Wheel Base Fleet Side 318 Automatic With Original Bed ! on 2040-cars

Year:1964 Mileage:25263
Location:

Athens, Alabama, United States

Athens, Alabama, United States
1964 D 100 Short Wheel base fleet side 318   Automatic with original bed !, image 1
Body Type:Pickup Truck
Vehicle Title:Clear
For Sale By:Private Seller
Engine:318
Transmission:Automatic
VIN: 90117664 Year: 1964
Make: Dodge
Model: Other Pickups
Trim: base
Drive Type: AUTO
Number of Cylinders: 8
Mileage: 25,263
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"This is a 1964 D100 Has some rust on the step in's at the doors but they are strong enough to hold at least 275 LBS. The bed has some rust on the sides where the bed held some water but they would be easy repairs. The dash and instruments are all original and the floor boards are still strong. All the glass is original and NO CRACKS! The 318 engine will run and go but truck needs brakes re-done. This was going to be Father/Son Project but we don't have time to do it. Great truck to restore or build Rat/Rod.."

 This is a  Solid 1964 D-100  This is a Fleetside short wheel base that has original wood and rails in the bed. The truck body is very good, just needs some TLC.  All the glass is original and NO CRACKS! The 318 engine will run and go.  Has some rust on the step in's at the doors but they are strong enough to hold at least 275 LBS. The bed has some rust on the sides where the bed held some water but they would be easy repairs. The dash and instruments are all original and the floor boards are still strong. All the doors open and close as they should and the hood also operates as it should.  Bakes need Master Cylinder and Wheel Cylinders.  This was going to be Father/Son Project but we don't have time to do it. Great truck to restore or build Rat/Rod..

Auto Services in Alabama

Wathas ★★★★★

Auto Repair & Service, Towing, Automotive Roadside Service
Address: Lexington
Phone: (205) 921-2401

Warren Tire & Auto Center ★★★★★

Auto Repair & Service, Tire Dealers, Gas Stations
Address: 409 University Blvd E, Fosters
Phone: (205) 758-2739

Southern Automotive Group Inc ★★★★★

New Car Dealers, Used Car Dealers
Address: 714 W College St, Lester
Phone: (931) 347-4830

Professional Collision Springhill ★★★★★

Automobile Body Repairing & Painting
Address: 3222 Spring Hill Ave, Prichard
Phone: (251) 471-1279

Professional Collision ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 1040 Schillinger Rd S, Wilmer
Phone: (251) 639-9545

Precision Tune Auto Care ★★★★★

Auto Repair & Service, Brake Repair, Automobile Diagnostic Service
Address: 1328 1st St N, Columbiana
Phone: (205) 358-7779

Auto blog

Chrysler readying Hellcat V8 with Viper-like power

Tue, 21 May 2013

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.

Chrysler extends fuel tank warranties on LX cars, NHTSA ends probe

Tue, 18 Feb 2014

The National Highway Traffic Safety Administration has ended its investigation of 153,817, 5.7-liter and 6.1-liter Hemi V8-powered 2006 Chrysler 300, Dodge Charger and Dodge Magnum models after reports of stalling. Chrysler has responded by granting a lifetime warranty on the fuel tanks for these vehicles.
NHTSA received 299 reports of engines stalling while the models were stopped or driving at low speeds, and began an investigation. The government agency found that the control valve shutoff float in the V8s' 19-gallon fuel tank could malfunction if the fuel had too high of an ethanol content. In many cases, the valve would break in the open position, allowing the tank to be overfilled, which would then cause the cars to stall. However, there were no accidents reported, and the vehicles could be restarted immediately.
There will not be a recall on these vehicles because, "the condition represents a low risk to motor vehicle safety and is adequately addressed by Chrysler's extended warranty," NHTSA said to The Detroit News.

2015 Dodge Charger R/T NHRA Funny Car burns rubber into SEMA [w/video]

Tue, 04 Nov 2014

Fiat Chrysler Automobiles is showing off a completely redesigned Dodge Charger Funny Car at this year's SEMA Show in Las Vegas and it's ready to blow through the NHRA timing lights next year. Initially, the shape might look like any of the other entrants in its class burning through the quarter mile, but this is the first comprehensive rethink for the racecar's aerodynamics since 2006, says Dodge.
Draped in classy red and black Mopar livery, the 2015 Dodge Charger R/T NHRA Funny Car tries to share the front and rear styling with its roadgoing counterpart, plus the scallops along the side, but this racer is all about crossing the finish line first.
The major goals for the redesign included making the body stronger and lighter without sacrificing aerodynamics, and that has been done with materials like Kevlar and carbon fiber. However, engineers have accomplished even more. By moving the cockpit further back, they've increased engine clearance and improved driver visibility.