2006 Dodge Ram 2500 St Crew Cab Pickup 4-door 5.9l on 2040-cars

Auto blog

SRT reveals Satin Vapor Edition 300, Charger and Challenger SRT models

With the exception of some notable truck and van introductions, Chrysler brands have tended to use the Chicago Auto Show to bring out new special editions, pimp their aftermarket parts support or indulge in the occasional flight of fancy. That plan is holding true for 2014, as well. Cases in point are these new Satin Vapor Editions of the 2014-model-year Dodge Challenger, Dodge Charger and Chrysler 300 - all from SRT.
The Satin Vapor name may sound like a failed 1970s glam-rock band, or a pseudo-gynecological diagnosis from the Old West, but is, in fact, pretty much a tape-and-trim package for this trio of hi-po Mopars. 300, Challenger and Charger alike come shod with 20-inch aluminum wheels finished in Black Satin Vapor Chrome, and are accented with Satin Black bits aplenty. The 300 gets blacked-out mirrors, spoiler and roof; the Challenger applies it to mirrors and its fuel door; while the Charger has the stuff covering its roof, hood and Super Bee tail graphic.
Interiors of the cars have been mildly updated as well, with all three getting some combination of Nappa leather, ultra-suede and carbon-fiberish finishes.

2015 Dodge Challenger looks fresh, still plenty retro [w/video]

It was the Ford Mustang that kicked off the retro-styled muscle car renaissance back in 2005, but it was the Dodge Challenger that served as the movement's poster child, with its unabashedly retro looks. Over the years, though, as the Mustang and the Chevrolet Camaro were freshened and upgraded, the look of the big Dodge has remained largely consistent since its 2008 debut. For 2015, the Challenger has received a big freshening, boasting strongly revised front and rear ends and (finally, finally, finally) a redesigned interior.
Let's talk about that new cabin first. It's basically been plucked directly from the redesigned Charger, and boasts the same seven-inch IP display. The center stack's miserable, last-gen display has been replaced by an expansive, 8.4-inch UConnect system. Material quality should see a solid boost with the new cabin, as well.
The exterior, meanwhile, sees a revised front fascia with LED halo lights, as well as new grille inserts. A functional shaker hood scoop is a must-have extra on the V8 models, while the back of the car is highlighted by a new set of LED taillights that don't use the "Racetrack" design of Dodge's other models.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.