2001 Ford E-350, Church Van, Bus, 15 Passenger, 7.3 Diesel on 2040-cars

Auto blog

Automakers' rush on aluminum may result in shortage

Aluminum is the new buzzword in the automotive industry. The latest Range Rover and Range Rover Sport both take advantage of the lightweight material to shave huge amounts of body fat (only it's called "aluminium" over there). Audi and Jaguar have been using the stuff for years in their A8 and XJ, respectively, and now, aluminum is going mainstream, arriving on the 2015 Ford F-150.
While we're excited to see aluminum make an impact outside the premium market, its widespread adoption apparently won't come without some problems, notably in terms of supply. "There isn't an automotive manufacturer that makes vehicles in North America that we're not talking to," Tom Boney, of Novelis, the largest global supplier of aluminum sheetmetal, told The Detroit News.
According to Boney, Ford's use of aluminum on such a large scale has forced auto manufacturers in "every boardroom" to reconsider their plans following the F-150's unveiling, for one simple reason: there's not exactly enough aluminum to go around, at least in the short term. The auto industry presently only accounts for six percent of the aluminum sheet produced, but as the material is adopted by more and more brands, that figure is expected to swell to 25 percent within the next six years.

NHTSA upgrades Ford floor mat unintended acceleration probe

According to a Bloomberg report, the National Highway Traffic Safety Administration has upgraded an investigation into complaints of unintended acceleration lodged against Ford vehicles. The investigation began in June of 2010 when just three complaints had been received and it only concerned the Ford Fusion and Mercury Milan, but this was at a time when the phrase "unintended acceleration" made grown men go pale. With 49 additional complaints received since then, the investigation has been reclassified as an engineering analysis - the last phase before a recall - and it has been expanded to include the Lincoln MKZ, making for a total of "around 480,000" units affected between the three sedans from the 2008 to 2010 model years.
The ostensible cause is that floor mats are trapping the accelerator pedal, but according to a Ford statement at the time, the entrapment is due to owners placing the optional all-weather floor mats, or aftermarket floor mats, on top of the car's standard floor mats. NHTSA has backed up that assessment, pinning the blame on "unsecured or double stacked floor mats."
On the face of it, it would appear that NHTSA has upgraded the status not because of Ford's error, but owner error, and Ford has stated publicly that it is "disappointed" in NHTSA's move. On top of NHTSA still being skittish after that other unintended acceleration debacle, it could be seen to be taking its time investigating all of the variables: it's reported that Ford changed its accelerator pedal design in 2010, a "heel blocker" in the floorpan has been considered a potential culprit in how the floor mats could be trapping the pedal, some drivers have said the floor mats weren't anywhere near the pedal, and according to a report in the LA Times, in "a letter sent by Ford to NHTSA in August 2010, the automaker said it found three injuries and one fatality that 'may have resulted from the alleged defect.'"

2015 Ford Mustang production to begin on July 14? Not quite, says Ford

Mustang6g.com believes that it has unlocked start date for 2015 Ford Mustang production citing a Ford dealer communiqué. According to the report, job one on the 2015 hardtop will allegedly start in just a few days, on July 14, although units that are known as "OK to Buy" won't enter production until September 9. The cars built between those dates are most likely final pre-production cars for the executive test fleet, and will likely include the cars we'll be driving at the media launch.
Sun worshippers, meanwhile, would seem to have a longer wait. Job one on the droptop supposedly isn't slated to start until September 14, with production models starting on October 27. As is the case with the hardtop, these final pre-pros are for the execs and media to test, while actual dealer orders will come from vehicles made after the October date.
After speaking to Ford, though, we wouldn't put a great deal of stock in those dates as reported. We reached out to Said Deep, Ford's North American Product Communications Manager.