2012 Ford Edge Se Ecoboost Cruise Ctrl Alloy Wheels 27k Texas Direct Auto on 2040-cars

Auto blog

Autocar pits Formula Ford against Germany's finest

Ford has quite the racing pedigree, but usually, its racers are relegated to the track. Not the new Formula Ford EcoBoost, though. It's a turbocharged, open-wheeled racer complete with a 200-horsepower, 1.0-liter, three-cylinder engine... and it's legal on the roads of the UK.
That's stressed in this video from Autocar, with the mag going so far as to show the car's tax disc and license plates. Being a road-legal offering, it's tempting to see just how well an open-wheeler that delivers racecar-like performance while also netting over 100 miles per gallon (assume this is on the British cycle, for obvious reasons) stacks up against modern performance cars.
Autocar lined up the Formula Ford against an Audi R8 V10, a BMW M6 Gran Coupe and a Mercedes-Benz A45 AMG in a number of situations to see which would come out on top. Take a look below for the full video.

2015 Ford F-150 shaves 700 pounds, adds 2.7-liter EcoBoost [w/video]

The Ford F-150 is one of the best selling vehicles on the planet. Considering that, one can imagine that when it comes time for a redesign, there are hardly any half measures. For its lucky thirteenth generation, Ford has gone all-in on the single most important vehicle in its portfolio, redesigning it from the ground up.
The big news is the F-150's new, lightweight, Atlas-inspired body. Ninety-three percent of that new body is made from a sort of aluminum alloy not unlike what the US military uses in its M2 Bradley fighting vehicles and Humvees, and it accounts for up to 70 percent of the F-150's 700-pound weight reduction. As a side benefit, the aluminum body should prove more resistant to dents and dings. Built Ford tough, indeed.
If you're wondering where the other 30 percent of that 700-pound weight loss went, 8.5 percent (60 pounds) came from the increased use of high-strength steel (up from 23 percent to 77 percent) in its ladder-box frame. Ford claims this steel is comparable to some of the heavy duty pickups used by its competitors, with a PSI rating of 70,000.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.