2008 Ford F-250 4x4 Crew Cab White Lariat Diesel 6.4l V8 on 2040-cars

Auto blog

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.

Auto critic calls out Corvette, Mustang and Cherokee faithful

Most automotive purists fear change, but not without reason. Change, after all, did kill big-block V8s, along with most station wagons and manual transmissions. But change has also brought with it far more performance, safety and fuel economy - not to mention ridding the world of shag carpet interiors, bias-ply tires and those horrible motorized seatbelts of the early '90s.
By this time next year, the Chevy Corvette, Jeep Cherokee and next-generation Ford Mustang will all be on sale and will all, in some way, have angered or offended purists. To those critics, Mark Phelan of the Detroit Free Press is preemptively telling them to stop complaining - at least until they've all been driven. From the Corvette's square taillights and the Cherokee's radical nose to whatever pony car purists will harp on the 2015 Mustang for, Phelan's column points out the positives of automotive evolution and the negatives of staying the course for too long. That's fair enough, but do you think Phelan is on point, or all wet? Head on over to the Detroit Free Press to read his words, then have your say in Comments.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.