** 1999 Ford F350 Xlt ** Super Duty ** 4x4 ** Dually ** V10 ** Truck on 2040-cars

Auto blog

White House clears way for NHTSA to mandate vehicle black boxes

At present, over 90 percent of all new vehicles sold in the United States today are equipped with event data recorders, more commonly known as black boxes. If the National Highway Traffic Safety Administration gets its way, that already high figure will swell to a full 100 percent in short order.
Such automotive black boxes have been in existence since the 1990s, and all current Ford, General Motors, Mazda and Toyota vehicles are so equipped. NHTSA has been attempting to make these data recorders mandatory for automakers, and according to The Detroit News, the White House Office of Management Budget has just finished reviewing the proposal, clearing the way. Now NHTSA is expected to draft new legislation to make the boxes a requirement.
One problem with current black boxes is that there's no set of standards for automakers to follow when creating what bits of data are recorded, and for how long or in what format it is stored. In other words, one automaker's box is probably not compatible with its competitors.

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.