2000 Ford F-350 Flat Bed Dually 2x4 on 2040-cars

Auto blog

Watch these videos of an NHRA racer's bodywork blowing off into a crowd

Just a few months ago, fan safety at racetracks was a hot topic following the last-lap NASCAR Nationwide Series crash at Daytona that sent large pieces of racecars into the grandstands injuring 33 fans. Now, a freak incident at a National Hot Rod Association event resulted in a drag racer's bodywork flying into the crowd at the NHRA Four-Wide Nationals in Charlotte over the weekend. The carbon-fiber body of Robert Hight's Ford Mustang funny car blew off toward the end of a run when his engine exploded, but fortunately, the two fans evaluated after the incident were later released without serious injury.
As you can see in the image above, the body flew high into the air before landing on a walkway in front of the grandstands, a bit of happenstance that likely gave most fans enough time and space to move out of the way. Scroll down to watch a couple of videos showing what happened, including one from a fan's perspective that also reveals what appears to be part of the body's metal bracing landing dangerously close to the crowd.

Ford cleans up painting process with cameras

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.

2015 Ford F-150 shaves 700 pounds, adds 2.7-liter EcoBoost [w/video]

The Ford F-150 is one of the best selling vehicles on the planet. Considering that, one can imagine that when it comes time for a redesign, there are hardly any half measures. For its lucky thirteenth generation, Ford has gone all-in on the single most important vehicle in its portfolio, redesigning it from the ground up.
The big news is the F-150's new, lightweight, Atlas-inspired body. Ninety-three percent of that new body is made from a sort of aluminum alloy not unlike what the US military uses in its M2 Bradley fighting vehicles and Humvees, and it accounts for up to 70 percent of the F-150's 700-pound weight reduction. As a side benefit, the aluminum body should prove more resistant to dents and dings. Built Ford tough, indeed.
If you're wondering where the other 30 percent of that 700-pound weight loss went, 8.5 percent (60 pounds) came from the increased use of high-strength steel (up from 23 percent to 77 percent) in its ladder-box frame. Ford claims this steel is comparable to some of the heavy duty pickups used by its competitors, with a PSI rating of 70,000.