1963 Ford Fairlane Squire Wagon. Very Rare! on 2040-cars

Auto blog

NHTSA closes probes on Jeep Grand Cherokee, Ford Freestar and Mercury Monterey

The Detroit News reports the National Highway Traffic Safety Administration has officially closed its investigations into 2012 Jeep Grand Cherokee, 2004-2005 Ford Freestar and Mercury Monterey models. The separate probes found no issues that pose safety concerns. NHTSA began investigating certain Grand Cherokee SUVs over complaints that power steering hoses could detach during operation, thereby increasing the risk of a vehicle fire. Of the 24 reports of failure, none alleged smoke or fire in the engine bay, and Chrysler has since modified the power steering cooler assembly to reduce the likelihood of the failure.
Meanwhile, certain Ford Freestar and Mercury Monterey vehicles garnered a government probe after receiving complaints that the models were equipped with faulty scissor jacks. The agency had received six reports of the jacks failing or causing injuries, including one incident that resulted in a fatality. But NHTSA says the jack failure rate is similar to those found in other vehicles. In those six cases, the government agency found the jacks were being used for something other than changing a tire, and investigators could not determine whether the emergency brake was set or the rear tires were properly chocked.

Ford making Fusion production moves to challenge Camry on volume

The Ford Fusion may already beat the Toyota Camry in terms of models offered, transaction price and sales increase so far this year, but if the Fusion wants to make a run at the title of best-selling car in the US, Bloomberg reminds us that volume is key. Opening a second production line at the Flat Rock, MI assembly plant will reportedly allow Ford to produce around 350,000 Fusions annually, which compares Toyota's ability to crank out 475,000 Camrys and Honda's capacity to build around 450,000 Accords.
For the Fusion, that's an extra 100,000 units compared to the car's current pace, and the article adds that the Fusion is "Ford's best shot" to regain the passenger car sales crown - a title it (or any other US automaker, for that matter) hasn't held since the mid-1990s. Despite hiccups with recalls and fuel economy numbers, the Ford Fusion is still red hot when it comes to sales. Fusion sales are up 13 percent so far this year (compared to a 0.6 percent decrease for Camry), and its average transaction price of $26,343 is about $2,300 more than its rival from Toyota.
The Fusion's popularity has helped Ford improve its sales in California; the Dearborn-based automaker has a market share of 18 percent in the state, which is just a fraction of a percentage behind Honda. And this popularity should continue as Ford ups Fusion production and expands the model lineup even further for 2014 with a new 1.5-liter EcoBoost engine soon to become an option.

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."