Model A 1930 Coupe on 2040-cars
Rapid City, South Dakota, United States
1930 Model A Ford coupe. A very solid original car with rumble seat and rear mount spare. No body patches or rust out, fenders are very nice and solid as is the entire car. I will list what has been done so far, Rebuilt engine by Antique Engine Rebuilding, cyclinders bored, new pistons, rings ect, new valves and springs, crank turned, cam reground/replaced, new timing gears, oil pump, flywheel faced with new clutch and pressure plate, new throw-out bearing, and pilot bearing every thing has been completely rebuilt or replaced. This engine is new with less than five miles since installed back into the car. It also has a new Weber carb and intake on it, along with a new set of Reds headers.The starter was rebuilt with-in the last year and the generator last two. Engine is mounted with a Float-A-Motor front and rear. tranny was rebuilt about three years ago. It has a new set of gauges (oil and temp) mounted in a new bracket. New style dist. cap and rotor along with new style points and new wires and ends. Has a new water pump with a stainless shaft, also the engine has the 6:1 Snyders high compression head. The rebuild also includes new SS valves, new guides, new adjustable lifters, inserts on the main and rod bearings and resurfaced block. After I had the engine back in the car and running ( and Wow does it run nice!) I took it for a short drive, kind of fun to start out in low and just get the car rolling good and then shift into high, no power problems here. Other things I have done were to replace the junction box on the engine side of the firewall, replace some wiring, replace the gas gauge and float, ect. The car will need some brake work, the brakes stop the car like a Model A but could be better, I was considering juice brakes, but the original Model A brakes when up to snuff work just fine. The battery box and cables have been replaced also. If there are more question call 605-791-one four nine seven, evenings are best. The hood, front bumpers, headlights and horn are not on the car at this time, but I can reinstall before shipping/delivery. Depending on how one would like to finish the car up consider the work that has been done thus far, you could go old school hot-rod or very well hidden souped up original. (The V-8 wheels are available separate of the car because I thought some may not want them.) I will expect $500.00 down through pay-pal with-in 48 hrs of sale and the balance wire to wire bank transfer. I will help with loading ect. if you need the car shipped to you. To be sold with-in the 48 States Only! thanks for looking! |
Ford Model A for Sale
- 1929 chevrolet tudor sedan 4" chop v8 sbc rolling chassis hot rod rat chevy ford
- 1928 ford roadster, hemi powered, all steel(US $39,900.00)
- 1928 ford model a tudor antique car(US $19,800.00)
- 33 ford vicky sedan, hot rod show car pro touring flames henry ford all steel(US $60,000.00)
- 1931 model a pickup truck late 31 steel roof 32 style bed project barn find
- 1929 ford model a special coupe showroom condition(US $21,500.00)
Auto Services in South Dakota
Peterson Automotive ★★★★★
Milbank Ford & Mercury Inc ★★★★★
Fast Auto Glass ★★★★★
West Side Wheels ★★★★
Palmlund Sales and Service ★★★★
Napa Auto Parts - Lake Benton Parts House ★★★★
Auto blog
Ford confirms launch of new Tourneo vans and Ecosport in Europe for Geneva
Sun, 24 Feb 2013We've already seen plenty of what the Geneva Motor Show will have in store for us in less than two weeks, but most of the confirmed debuts that were announced so far have generally been luxury or performance cars. Ford, on the other hand, will be showing off a couple of its new family-friendly models for European buyers to enjoy.
On the larger side of things, the full range of Tourneo vans (shown above) will be on display, including the introduction of the new Tourneo Courier model, but Ford will also be showing off the all-new EcoSport crossover, which is based on the automaker's Global B platform and will be positioned beneath the Kuga, better known here as the Escape. The subcompact EcoSport was originally unveiled at the Beijing Motor Show last April.
NHTSA investigating 725k Ford, Mercury vehicles for stalling issue
Mon, 25 Feb 2013Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.
Ford says 70% of its models to get stop-start by 2017
Sun, 15 Dec 2013Ford is following up on a report we posted a few weeks back that the Blue Oval would be adding stop-start technology to its entire model range. Now, the Dearborn-based automaker has announced that the fuel-saving feature would be available on 70 percent of the company's range by 2017.
Ford claims the technology will improve fuel economy by around 3.5 percent, although its actual effect will vary based on how the owner drives - apparently up to a 10-percent improvement is possible for those who sit in heavy traffic (Los Angelenos, this means you). The latest recipient of the technology is the updated 2014 Ford Fiesta with the company's three-cylinder EcoBoost powerplant.
Part of the reasoning for the new addition has to do with cost. Ford claims the tech is affordable and easy to implement. "Simply put, Auto Start-Stop helps customers use less fuel, which is an important component of Ford's Blueprint for Sustainability," Ford's global powertrain vice president, Bob Fascetti, said.