2006 Ford F-650 on 2040-cars

Auto blog

Ford brings FPV Falcon production in house [w/video]

For the first time since 1976, Ford of Australia is bringing the assembly of its stonking Ford Performance Vehicle line back in-house to the company's Broadmeadows and Geelong facilities. That's a point of pride for FPV, which builds high-performance versions of the Australian Falcon model like the F6, GS and the heroic GT seen here.
In the video below, we hear FPV employees talking in hushed tones about the important legacy that cars like the GT have for Australian gearheads of all stripes, and how proud they are to say that hand-built machines like this GT R-Spec with its Boss 355 engine are now rolling out of their home base. For our part, we're just dying to drive this version of the Coyote V8; the engine is rocking a "Miami" supercharger from Harrop and makes some 450 horsepower.
Continue on below for the video, or you can check out some images of the new FPV at the facility, as well as a gallery of the GT R-Spec car.

Hurricane Sandy cost automakers 15,000 vehicles, may have ruined up to 200k

Hurricane Sandy was the largest Atlantic storm in US history, and its total economic impact is just now coming into view. According to Automotive News, Toyota, Chrysler, Nissan and Honda are set to scrap around 15,000 new vehicles ruined by the storm. Nissan alone accounts for about 40 percent of those, with 6,000 Nissan and Infiniti models deeded "un-saleable" due to damage. The company saw 56 dealerships shuttered due to the storm, but 51 of those have since reopened.
Toyota, meanwhile, had some 4,000 vehicles at its Newark port facility, and of those, 3,000 may be scrapped. An additional 825 were dealer inventory when they were ruined. Honda and Acura dealers are reportedly sending 3,440 vehicles to the salvage yard. By comparison, Chrysler weathered the storm fairly well with 825 units destroyed, while Hyundai suffered only 400 lost units and Kia scrapped around 200.
As you may recall, Fisker also suffered some losses, and Automotive News reports the manufacturer saw 320 Karma models damaged beyond repair. Ford and General Motors have yet to come up with estimates, and no automaker has commented on the full cost of replacing the vehicles.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.