Find or Sell Used Cars, Trucks, and SUVs in USA

1996 Honda Civic Lx Turbo Vitara Mini-me Swap Vtec 250+ Wheel Horsepower on 2040-cars

US $3,800.00
Year:1996 Mileage:7000
Location:

Oconomowoc, Wisconsin, United States

Oconomowoc, Wisconsin, United States

For sale is a cypress green 1996 Honda Civic LX sedan. This car has been totally rebuilt and turbocharged with less than 7,000 miles on most everything. Body has about 219,000 miles. I have been putting my heart and soul (along with blood and tears) into this build, but I'm at a point in life where I don't have time for this hobby and I'd like to buy a house.
The list of things done to this car is lengthy:
Cylinder Head:

97 EX VTEC head (VTEC is all wired and pinned to the ECU, but doesn't work because the computer wasn't programmed for it)
Supertech valve springs
new OEM Honda valve stem seals
ARP head studs
Black wrinkle painted valve cover
All new Honda OEM gaskets

Engine Block:

96 LX block
Bored over to 75.5mm stock sleeves
75.5mm YCP Vitara pistons
Custom length forged rods from RC Autoworks (to bring compression ratio up to approx. 8.5:1)
Custom ground block to allow clearance for rods
ARP rod bolts
Polished crankshaft
ACL Race main and rod bearings
All new Honda OEM gaskets

Gates Racing timing belt
New Honda OEM water pump
New Honda OEM timing belt tensioner

Steel oil pan with welded -10 AN turbo oil return fitting
Magnetic oil drain plug
Detergent free 30wt oil used for proper break-in procedure, then only Mobil 1 full synthetic 5w30 oil used

D16Y8 intake manifold port-matched to integra LS 60mm throttle body (uses the LS throttle body gasket)
Hondata thermal intake manifold gasket (reduces intake air temps)
Speedfactory 4 bar map sensor
Lancer Evolution 560cc fuel injectors with adapter harness and resistor box (no wiring hacks)
Walbro 255 fuel pump
Ebay 2.5" aluminum intercooler piping kit with silicone couplers and T bolt clamps
Lancer Evolution front mount intercooler
Genuine HKS blow-off valve (sounds awesome)

New Precision 5431 MFS turbocharger
• MFS (Machined From Solid) 54mm inducer compressor wheel 
• "E" compressor cover 3.0" inlet/2.0" outlet 
• 57mm exducer T31, 76 trim turbine wheel 
• Turbine housing: 
- T3 .63 A/R with 5 bolt discharge (without wastegate hole) 
• 360° journal bearing system
Custom cold-air intake in driver's wheel well
Heat wrapped Ramhorn exhaust manifold
Tial 38mm Wastegate (15 PSI spring) recirculated into exhaust (no annoying loud wastegate)
2.5" V band exhaust with upstream O2 sensor and Aem UEGO wideband O2 sensor
2.5" stainless exhaust turbo-back NO Catalytic convertor
(car will not pass emissions, it has been converted to OBD I)
Cheap Ebay axle-back muffler actually sounds great, not loud or raspy at all

Engine Management:
OBD I PO6 ECU from Phearable.net
Converted to a VTEC computer
VTEC is wired in and pinned to the Ecu harness (Vtec does not work due to the ECU program)
OBD II to OBD I conversion harness
Tuned on Chrome On 93 octane by Beeyond Engineering
Tuned with boost leak and bad wastegate- maxxed out at 250whp @ 18 PSI
Changed to Tial wastegate, fixed vacuum/boost leak, and did mini-me swap (VTEC head) since then WITHOUT getting re-tuned.
Fuel cut is at 18PSI (cannot go higher)
With a new tune this setup can easily hit 350 HP

Transmission:
Stage 4 Competition Clutch
Stock flywheel
Transmission has had no work done besides all new Honda OEM external oil seals
And short-throw shifter
Slight occasional grind has just started into third (like last 500 miles and doesn't happen all the time, just trying to be honest) seems like it happened when I switched from Royal purple to Mobil 1 gear lube. Maybe a switch back is the cure
My next project would be an MFactory limited slip differential and rebuild the transmission, but I do not have the time or funds for that at this point in my life.
Tires do spin in second gear, it's cool, but traction is speed!
Axles are Newer stock replacements, maybe 30,000 miles on them

Tires are Falcon Azenis with a lot of tread left
Wheels are QT Alloys 16" stripped, primed and painted metallic black by me (paint is chipping, doesn't look awful)
Black locking lug nuts
Also have 4 original steelies with hubcaps (tires are not good)

Suspension/brakes:
New Koni shocks
Tein S tech lowering springs (perfect drop, Perfect Ride)
All polyurethane bushings except rear trailing arm and rear compensator arm, which are New OEM Honda bushings
Civic SI rear sway bar
All 4 New Timken wheel bearings
New slotted/drilled front rotors
New front upper control arms, all new ball joints
Tie rods are new, but the boots are already cracked (kind of upset about that) may need to be replaced soon


Interior:
White faced gauges with LED lighting
Autometer Phantom boost and mechanical oil pressure gauge (steel braided -3an oil line doesn't leak) mounted in gauge bezel
AEM UEGO wideband white faced gauge in single pod on A-pillar
Blitz turbo timer installed in coin pocket
HDI electronic boost controller has a high and low setting that can be adjusted from inside the cabin electronically. It controls a MAC valve in the engine bay that regulates the pressure the wastegate sees
Black and tan interior plastic pieces (not painted, actual OEM Honda)
RSX type S Titanium (tan) leather front seats custom fitted to the civic bolt locations
All airbags still intact and hooked up
Stock tan cloth rear seats
Aftermarket speakers in front doors and rear deck
NO stereo, an adapter harness is already wired in as well as wiring for a subwoofer in the trunk
NO cruise control
NO air conditioning
"rattler" brand aftermarket keyless entry
Passenger front power door lock doesn't work
Slight squeaking noise from rear drums (new shoes will be included, but not installed)

Type R polyurethane black front lip
M3 style side mirrors with LED arrow blinkers, painted to match the car
Projector headlights with LED halo and the inside painted to match the car
Body isn't perfect, dents on driver's side rear door and dents on passenger's front door (ill try to show this in the pictures)
Windshield has a crack
OEM rear spoiler was installed and has a little clear coat peeling
I like to say "all go and no show"

This car still averages 30 MPG with "spirited" driving!!


Local test drives for SERIOUS buyer's only with me or my father ONLY, I've learned that lesson.
Thanks for looking, Message me (Adam) for more info or to set up a time to view the car. Please keep in mind, I live in Oconomowoc and I also work 3pm-11pm weekdays, so mornings will be the best bet

Deposit is due immediately at auction end, and full payment will be expected within 7 days

Auto Services in Wisconsin

Wildes Transmission ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 6720 US Highway 12, Tomah
Phone: (608) 378-4393

Waller`s Auto Glass Express ★★★★★

Automobile Parts & Supplies, Wheel Alignment-Frame & Axle Servicing-Automotive, Brake Repair
Address: 108 W 3rd St N, Ladysmith
Phone: (715) 532-5282

Van Hoof Service ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Towing
Address: Neenah
Phone: (920) 766-9031

Transmission Shop ★★★★★

Automobile Parts & Supplies, Auto Transmission
Address: 211 Lake Ave, Wilmot
Phone: (847) 356-8515

Tracey`s Automotive ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Inspection Stations & Services
Address: 802 S 9th Ave, Wausau
Phone: (715) 845-9325

T & N Tire Service ★★★★★

Auto Repair & Service, Tire Dealers, Tire Recap, Retread & Repair
Address: 2923 N Teutonia Ave, New-Berlin
Phone: (414) 562-6211

Auto blog

Honda Civic Tourer reminds us why we love wagons

Tue, 10 Sep 2013

It was the early 1990s when the last Honda Civic Wagon graced our shores, looking more like a squat five-door hatchback with an extra dose of charm. Well, Honda debuted the newest Civic Wagon Tourer at the Frankfurt Motor Show today, but, as we reported last month, it's a European model that will go on sale there early next year. There's still no word of it coming to the US.
The Civic Tourer was designed by Honda's European studio, and its overall look comes across as more muscular, sporty and stylish than both the sedan and two-door coupe, with bulging fenders and revised windows. Adrian Killham, large project leader for the Civic Tourer, has commented on the styling, saying, "Recently launched cars have tended to follow a similar style. The Civic Tourer has a different balance and appeal." We appreciate the sentiment, and the Tourer's shape is a big reason why we like it.
But we also like the 22 cubic feet of cargo space with the rear seats up, which grows to a gargantuan 59 cubic feet with the rear seats folded down. The big Civic will be powered by either a 1.8-liter four-cylinder petrol engine with i-VTEC or a 1.6-liter Earth Dreams i-DTEC diesel engine. Manual and automatic transmissions will be offered.

Honda may recall up to 1M vehicles for airbag issue, following Toyota's lead

Mon, 16 Jun 2014

It seems Toyota won't be the only one recalling the faulty Takata airbag inflators for long. Honda insiders in Japan claim that the company is getting close to announcing its own worldwide campaign that would begin before the end of June.
Unnamed sources close to Honda in Japan tell Automotive News that the company is pursuing an internal investigation into possibly affected models and is working with Takata to gather more information. They claim that it could involve even more than the 1.14 million cars worldwide that the automaker covered under the first recall for the problem in April 2013, including 561,000 vehicles in the US.
Toyota jumpstarted this process last week when it recalled over 2 million cars worldwide, including 844,277 in the US. Soon after, the National Highway Traffic Safety Administration began a preliminary evaluation into the issue following six reported incidents, and started assembling data about potentially affected models from Toyota, Honda, Mazda, Nissan, Chrysler. NHTSA also began investigating Takata itself.

Toyota, Honda, Mazda and Nissan recall 3.4 million vehicles for faulty airbags

Thu, 11 Apr 2013

Most vehicle recalls that take place these days are a result of some problem that happens during the manufacturing process by the automaker, but as we see here, parts suppliers can also factor in to problematic safety issues. Automotive News is reporting that a total of 3.4 million vehicles produced by Japanese automakers between 2000 and 2004 are being recalled globally due to faulty airbags produced by an outside supplier, Takata Corp.
According to the report, vehicles from Toyota, Honda, Nissan and Mazda are being recalled because of passenger front airbags that do not inflate properly. Globally, Toyota is said to be recalling around 1.73 million cars including 510,000 in the US composed of Toyota Corolla, Matrix, Sequoia and Tundra as well as the Lexus SC430 for the 2001 through 2003 model years; this is the second time this year the 2003 Corolla and Matrix have been recalled for an airbag problem. Honda is recalling 1.14 million models, Nissan another 480,000 and Mazda 45,463. The article says that Takata supplied faulty airbags to non-Japanese automakers, but it did not specify which ones.
Honda and Toyota have released information on their own websites about the recall, while Nissan and Mazda have not yet commented. Read official press releases from Honda and Toyota, below, and look for updates as we have word from the others.