2010 Mercury Milan Base Sedan 4-door 2.5l on 2040-cars

Auto blog

Report: Last Mercury for retail business built on Sunday

Ford is already well into winding down its Mercury line, and the autoamker has announced that the very last of the soon-to-be dead brand's products built for retail sales was manufactured on Sunday, October 3. The final Mercury Mariner rolled off of the assembly line at the company's Kansas City facility, putting an end to a brand with over 70 years of history behind it.
Even after the Mariner heads off into the automotive sunset, Ford says that it will continue to manufacture a handful of Mercury models for fleet and government service for a while longer, though mum's the word on how long we can expect that practice to continue.
Interestingly enough, according to USA Today, most incentives on Mercury vehicles have all but dried up, even as the brand's August production increased by 120 percent compared to July's figures. Instead of cash on the hood, some areas are offering no-cost maintenance or similar programs. Even so, Mercury has continued to out-sell Lincoln right to the end - besting Ford's luxury arm's sales by nine percent in August.

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.