1983 Datsun By Nissan 280zx Base Coupe 2-door 2.8l on 2040-cars
Tilton, New Hampshire, United States
Registered and inspected
Engine is in original non-restored condition and is sound and has been tested 2006 Replaced rear brake calipers, rotors, tie rods 2007 Replaced foot boxes , tail light gaskets, pulled side windows and resealed 2008 Updated air-conditioning to moderns standards, replaced condenser, dual friction center force clutch, front brake calipers. Replaced headliner and some of the vinyl in rear. 2010 Replaced shocks and struts with KYB's. Replaced front bushings 2012 Completely stripped out the interior of the car down to metal. Seal coated all metal surfaces on the floor and rear hatch, re-upholstered seats and replaced many interior parts. Replaced all carpeting. Installed new Bluetooth, digital radio with Infinity speaker system. Installed new air conditioning compressor 2013 New rims and tires to correct mileage problem. Repainted vinyl throughout interior Replaced speakers and put them back into original positions. Replaced rear glove boxes. Replaced starter/solenoid
Engine is in original non-restored condition and is sound and has been tested. 122,259 miles. Rims/tires that came on the car were too small, so the actual mileage is lower but unknown. We put less than 11,000 on it since we've owned it. Car has not been driven in the winter since 1985. This is an everyday 3 season car, or 4 season in a warm climate or if you are very adventuresome. Ground clearance is not really adequate for winter snows). If you are going to own one, drive it and enjoy it. We have brought it to local car shows and it is a serious people magnet. It is so pretty it is also a serious head turner when out and about. We hate to sell it but need the money and are losing money at this price. These cars go for a wide range of money depending on original or modified, mileage and states of repair or disrepair. I have tried to place a reasonable price on it. Appraised value in 2008 before: shocks, struts, $3,400 worth of interior work, rims, tires, sound system, and starter was $8,000 We do have the Nissan official Service manual to go with this and I have repaired it with a new hard cover binding. A ground effects kit was installed on the car before it came to us including both front and rear bumpers, lower side panels and the small wing in the rear. We liked them so we left them on. There are still small things that need to be fixed but for the most part we have kept up very well with pretty much everything as they came up. Next would have been one of those nice high end pain jobs with clear coats but alas we need some money as the economy has not been good to us. |
Nissan 280ZX for Sale
Auto Services in New Hampshire
R L Cycle & Auto Repair ★★★★★
Majestic Motors ★★★★★
Gurney`S Automotive ★★★★★
Colonial North End Subaru Mazd ★★★★★
Billerica Tire & Auto Ctr ★★★★★
Auclair`s Auto Body ★★★★★
Auto blog
UAW calls on US State Department to help with Nissan plant
Tue, 29 Apr 2014The United Auto Workers is calling for reinforcements in its ongoing battle with Nissan at the manufacturer's Canton, MS factory, where the Altima, Armada, Titan and NV (and eventually, the next Murano) are built. The union has been attempting to organize the employees at the factory for several years, but it's been largely unsuccessful.
Now, Reuters is reporting that the UAW is teaming with the IndustriALL Global Union and requesting intervention by the US State Department, with both groups accusing Nissan of using "threats, intimidation and fear" to keep the 5,600 workers at the facility from organizing. The two unions say this violates the guidelines of the Organization for Economic Cooperation and Development, an international organization dedicated to stimulating economic growth.
The UAW and IndustriALL are asking the State Department's National Contact Point to serve as mediator with Nissan, to make sure things play out fairly. Speaking to Reuters, though, there's at least one Michigan-based labor adviser that's skeptical of the move.
2014 Nissan Pathfinder Hybrid arrives with supercharged engine, 26 mpg combined
Wed, 27 Mar 2013Nissan just launched the fully redesigned Pathfinder for the 2013 model year, and now, there's a fuel-sipping hybrid version making its debut here at the New York Auto Show. The 2014 Pathfinder Hybrid packs all of the same features found in the standard crossover, but offers slightly better fuel economy and an improved cruising range, to boot.
The new hybrid is powered by a 2.5-liter supercharged engine (we're assuming it's a four-cylinder, though Nissan hasn't specified) coupled with a lithium-ion battery and 15-kilowatt electric motor, capable of producing 250 horsepower and 243 pound-feet of torque - 10 less horsepower but three more pound-feet than the standard V6 Pathfinder. Nissan says the hybrid crossover will be rated at 25/27 miles per gallon (city/highway), with a 26-mpg combined rating. This means that on a full tank, the cruising range of the Pathfinder Hybrid is a cool 526 miles.
What's cool about the hybrid packaging is that Nissan has managed not to have it interfere with any of the interior functionality - the Pathfinder Hybrid still packs just as much cargo and passenger space as its naturally aspirated sibling. Official pricing has not been announced, but Nissan expects the hybrid to command an additional $3,000 over the standard model.
US-built Infiniti Q50 engines to go into Euro-only cars
Thu, 12 Jun 2014Back in March, Infiniti announced that it would be adding a 2.0-liter, turbocharged four-cylinder to its Q50 line for European and Chinese buyers. Now, we know where that engine will be built.
Nissan's Decherd, TN facility will receive the $319-million investment, which will see a separate, dedicated line for the Infiniti engines. According to Automotive News, this is more than a line running alongside the Nissan operations - the Infiniti facility will sport its own unique architecture and interior lighting, in a bid to distinguish the premium line from its mass-market parent company.
The logistics of all this do seem, on the surface, quite screwy. Building a new engine on one continent for a car built on another that will eventually go on sale on a third doesn't seem too bright, although there is a catch here. The new engine will also find its way into the Mercedes-Benz C-Class, which will kick off production in Vance, AL later this year.