1973 Volkswagen Camper Van Bus - Very Straight Body And Very Little Rust! on 2040-cars
Portland, Oregon, United States
I acquired this van about three months ago but the
acquisition of another project is forcing me to sell this one. There
is absolutely nothing “drastically wrong” with this V-dub that made me give
up. I just realized that I’m not that
excited about it and would rather work on something else. So, in the interest of the fullest disclosure
possible, here goes.
Here’s the details. Purchased in April of this year from the estate of an elderly man who passed away. The vehicle has not been licensed since April 2005 so I’d assume that’s the last time it’s been driven to any extent. Had a V-6 (older Ford 2.6) that was awfully tired. After evaluating its condition and running it for a short while (couldn’t really drive it except in my driveway, clutch was pretty weak) I did not see any value in keeping this motor so I yanked it. It is gone but I still have the adapter plate and flywheel if someone is interested in installing another version of this motor (same basic motor as the 2.9 in older Ford Rangers and Bronco II’s). Body: Undoubtedly
this is the best characteristic of the bus.
It’s very straight with only minor dings and rust spots. The side panels look really, really
straight. The nose and tailgate area are
pretty good as well. Most of the small
dings seem to be in the corners and are very shallow. I would characterize the rust spots that I have
found as small and mostly surface. There
are two or three that have a different color of paint over them and may have
been bondo-ed over but I am fairly certain they were not rusted through as
there is still flex in these areas (from the sheet metal bending a bit but it doesn't feel rusted through at all). The worst of these are shown and are at the left front around the parking lamp and left rear around the tail light. I honestly think they look worse in the photo than they really area. The
area inside and below the windshield has peeling paint and minor surface rust
but is otherwise solid. I can’t find
anything but a bit of surface rust underneath.
Very good raw material here folks!
There were two body mods done to accommodate the V-6. The bottom
of the nose was cut out for the radiator fan and the rear “apron” (goes across
below the engine opening) was modified to be removable due to the extra size of
the engine. I am not a body expert but I really consider these two issues to be way less severe than taking on significant rust. Doors and hatches:
All hinges are tight, slider works fine (inside handle is broken), rear
gate and engine cover work great. I cannot find any rust to speak of on any door
or hatch other than minor surface rust around paint chips. All doors & hatches close with a very solid "thunk". Brakes: Seem to work (although I have not tested at high speed), fluid looks good. Emergency brake cable is broken. Glass: Absolutely great, no cracks or even any chips that I can see. Everything cranks up/down or open/shut as it should. Some seals are weathered but appear to be functional. Vehicle was sitting outside (in Portland where it rains a lot) but there are really no detectable signs of moisture entry. Electrical: No obvious signs of shorts or otherwise damaged wiring. Most things seemed to work (signals, headlights, horn) that I tested when the battery and engine were installed. Has provisions for two batteries running on an isolator. Fridge does run on 120 VAC. I am an expert on DC wiring and would characterize the system as slightly modified but reasonably well done. I would say you do NOT have to re-do the entire system but may need to modify or improve certain areas depending on what you intend to power it with. Propane system: Everything looks good but I cannot figure out how to turn on the gas solenoid. I can’t imagine that it’s terribly complicated. Gas is used only for the stove (fridge is 120 VAC only I’m pretty sure although it might run on DC as well). The tank appears to be about 2-3 gallons. Sink & plumbing look okay but I have not tested. Interior: Most of the
original panels (like on the front door) are good. The trim along the bottom of the camper
shell is pretty bad but looks to be easily replaceable. Camper area floor is in good condition (some
type of sheet vinyl). Carpet in cab area
is bad. Carpet over engine area is dirty
and pretty ugly. Dash has had 3 gauge installed and a few holes drilled. There are still two "coolant" heaters; one in the living area and the other in the cab. Engine: yanked!. I think you basically have 2 options with this rig: 1. Put in a Subaru flat-4 (this seems to be the most popular conversion) or 2) make it original. I still have the front radiator that goes in behind the guard currently welded to the front bumper mounts. It’s quite heavy duty. Some of the coolant lines were removed from the chassis but those could be easily reinstalled. I did leave the heaters in the front cab and the camping area. Fuel system: Condition is unknown. There’s a bit of surface rust in the filler neck. I put about 2 gallons in which didn’t leak out but the fuel pump on the engine wouldn’t draw so there’s either some kind of restriction or the fuel pump was bad from sitting with fuel in it for years. Removing the fuel tank for cleaning will be a lot easier with the engine removed. Drive train: Transmission goes into all gears (it’s a VW 4-speed with an adapter for the V6) and doesn’t make any bad noise but I haven’t driven it on the street yet. Rubber boots on transaxle half-shafts need to be replaced as they are split. Suspension: There do not seem to be any major defects. I jacked up the front end and all ball joints seem to be okay (I couldn’t find anything loose). Steering seems to be reasonably tight and smooth. Wheel bearing seem good & tight. Rear suspension seems quite taut. Misc: gas pedal
screws to mount to floor have broken off.
Transporting: I am willing to move the van a short distance if you need assistance. A tilt-bed hauler might have difficulty getting down my driveway so I could easily transport it a short distance to accommodate that. I could also locate temporary storage if that is required. Thanks for looking and please contact me if you are interested. You or your representative can inspect this rig at my home just about any time during daylight hours. Just contact me through this auction and I will send you my phone number. I’m off Canyon Road between Beaverton and Portland (Oregon). I would really like to impress that I'd like to be as accommodating as possible. If you have any special requests, please don't hesitate to ask. |
Volkswagen Bus/Vanagon for Sale
- 1971 vw bus sunroof camper, 1776cc,original paint, sidemount tent, needs nothing
- 1966 vw bus 13 window delux walk thur **running**
- 1971 volkswagen bus camper
- 1985 vw westfalia vanagon gl 98,158 original miles runs smooth ready to roll
- 1962 volkswagon, double cab with single cab front clip
- My baby blue bus
Auto Services in Oregon
Westgate Auto Ctr ★★★★★
University Honda ★★★★★
Trademark Transmissions ★★★★★
Tlk Automotive Repair ★★★★★
Shelby`s Auto Electric ★★★★★
Sears Auto Center ★★★★★
Auto blog
Volkswagen Multivan Alltrack Concept takes the luxury van life off road
Wed, 05 Mar 2014Volkswagen dug into its commercial vehicle fleet for its latest Geneva Motor Show concept, blending the versatile body of the T5 MultiVan with a luxuriously appointed interior, 4Motion all-wheel drive and a thrifty diesel powertrain.
That 177-horsepower diesel engine routes its power to the AWD system through a seven-speed dual-clutch transmission. Based on that alone, we'd expect the Multivan Alltrack's behind-the-wheel experience to be somewhat familiar. That all-wheel-drive system and van body contribute to the 21-degree approach and 15-degree departure angles of this soft-roading MultiVan.
What wouldn't be familiar is its exquisite cabin. Volkswagen opted for a nautical theme for the concept's interior, featuring grey-blue leather seats from Poltrona Frau and a floor finished in real wood. The dark wood trim can also be found throughout the interior, running below the windows and on the dash.
2014 Volkswagen GTI to start a new hot hatch era in Geneva
Tue, 26 Feb 2013The upcoming Geneva Motor Show is going to be stocked with important new production models and sexy concept cars, but hot hatch enthusiasts will undoubtedly see it as the coming out party of the MkVII Volkswagen GTI. And while we've only got European specifications and pricing to go on for now, we can tell from the get-go that the new GTI will be a proper heir to VW's hot hatch legacy.
This seventh-generation GTI is powered by a turbocharged, direct-injection 2.0-liter four-cylinder engine, which makes 220 horsepower and 258 pound-feet of torque in base form. For the first time ever, Volkswagen is also offering a performance pack for the GTI as well, which ups the horsepower to 230 (torque remains unchanged). With a slightly lower curb weight to push around - the new base car weighs 2,978 pounds versus 3,034 for the current three-door GTI - 0-62 miles per hour is now achieved in 6.5 seconds, and top speed is 153 mph. (Cars with the performance pack offer 0-62 mph in 6.4 seconds, and a 155-mph top speed.) Buyers my choose between a six-speed manual transmission or an optional six-speed DSG unit.
Visually, the new GTI has obviously adopted the slant-nosed looks of the MkVII Golf, though with plenty of added drama. The exterior is dominated by the 17-inch "Brooklyn" wheels wearing 225-section rubber, and the aggressive front fascia gets black honeycombed inserts in the upper and lower grille sections. At launch, Volkswagen will offer the GTI in three colors: the Pure White seen here, Tornado Red and Black. Tartan patterned seats are of course still an option for the interior, while the GTI-specific steering wheel and shift knob are standard.
VW using other manufacturing locations as leverage in battle with TN [w/video]
Sat, 26 Apr 2014We've reached a new step in the ongoing drama at Volkswagen's factory in Chattanooga, TN. The United Auto Workers recently dropped its opposition to the union vote and agreed that it wouldn't hold another ballot for at least a year. Now, the new question becomes where VW is going to build its forthcoming midsize SUV.
Earlier, it had been considered all but certain that the SUV, likely a production version of the CrossBlue concept (pictured above), would be built in Tennessee. However, it seems the Chattanooga factory might have competition to produce it. In emails obtained by The Detroit News, VW's lawyer wrote to the Tennessee economic development department in January saying, "While we understand there are some 'non-deal' issues that are causing a delay in the TN solution, VW has been successful in reaching agreement on terms at the alternative locations."
As previously reported, the state of Tennessee allegedly offered VW about $300 million in incentives to build the vehicle there and create an estimated 1,350 jobs, but it later rescinded the deal. Newly leaked documents from NewsChannel 5 (WTVF-TV) in Nashville allegedly show just how close that offer was to being completed. It appears that VW actually sent the government the first draft of a memorandum of understanding agreeing to the incentives, but the state removed the offer in late January.