Find or Sell Used Cars, Trucks, and SUVs in USA

1978 Chevrolet El Camino With Sbc 409 V8 And 9" Ford Rear End on 2040-cars

Year:1978 Mileage:104025
Location:

Tucson, Arizona, United States

Tucson, Arizona, United States

1978 Chevrolet El Camino

Listed below is an overview of the new parts and highlights of the car.  Mechanically everything on the car is new and has been replaced or rebuilt if necessary.  The car itself has 104,000 miles on the odometer, but it only has 1,500 miles on the new powertrain.

About 3/4 of the car’s original build sheet was found during the rebuild; it was built in Fremont, CA and sold by a dealership in Las Vegas, NV. From there it has spent its entire life in Tucson, AZ and it is currently a 3 owner car.  This car is free of rust and body rot; the only thing it needs is a nice paint job and you will have a great show piece or leave it as is and it will remain a great sleeper.  Outside of a paint job it will need a front end alignment from a good shop and the air conditioner will need to be topped off. I had the initial charge done over the winter and it was hard to get an accurate reading with the cold weather.

 

Engine Compartment:

SBC 409 V8 – 4 Bolt Main (see engine specs)

Energy Suspension Polyurethane Motor Mounts

Perma-Dry 1-Piece Oil Pan Gasket

Perma-Dry Valve Cover Gaskets

Edelbrock Dual Pane Aluminum Intake Manifold

Edelbrock 1407 4BBL 750 CFM Carburetor

Edelbrock 1721 Mechanical Fuel Pump 6psi

Sanderson Headers – Ceramic Coated

Pypes 2-1/2” Stainless Steel Performance Dual Exhaust System  

PROCOMP HP H.E.I. Distributor/Coil (60,000 Volt Coil)
Chrome Oil Pan

Chrome Timing Cover with Chevrolet Logo

Chrome Valve Covers with Chevrolet Logo

Chrome Oil Dipstick

Chrome Transmission Dipstick

Chrome Water Outlet

Chrome Brackets & Pulleys

Chrome 160 amp Alternator

Alternator Supply Wire Upgraded to 8 gauge

Chrome Heavy Duty Water Pump

GM Windshield Washer Reservoir

GM Coolant Reservoir

Windshield Wiper/Washer Motor

Battery Tray

Interstate Battery

Starter

Champion 2 Row Aluminum Radiator

N.O.S. 2-Speed Electric Fan from Lincoln Mark VIII

Hollister Road Lincoln Mark VIII 2 Speed Electric Fan 3-Relay Kit

Dayco Radiator Hoses

Stainless Steel Braided Hoses

Red Silicone Vacuum Hoses

Heater Core

Power Steering Pump – reservoir modified to accept hydroboost return.

Power Steering Hoses

Power Steering Box

High Efficiency A/C Condenser

A/C Evaporator Core

A/C System – Compressor & hoses from Classic Auto Air

Cruise Control Transducer

Blower Motor Resistor

Speedometer Cables (2)

Relay Center for Headlights with Prewire for Fog Lights

 

Transmission / Drivetrain:

 TH350 “K” Case Transmission – Rebuilt
Chrome TH350 Transmission Pan

G-Force Performance Racing Double Hump Crossmember

Energy Suspension Polyurethane Transmission Mount

B & M 70266 Super Transmission Cooler

9” Ford Rear Axle, 3.00, Posi-traction

Custom Driveshaft

 

Brakes:

Hydroboost Power Brake System

Hydroboost Pressure Hoses

Master Cylinder

Proportioning Valve for 4 Wheel Disc

Hydraulic Brake Hoses

Front Calipers

Front Rotors – Cross Drilled & Slotted

Rear Willwood Disc Brakes/Calipers – quad piston

Parking Brake Cables (3)

 

Body / Frame:

All Nuts & Bolts Replaced and Upgraded to Grade 8 or Class 10.8

Energy Suspension Polyurethane Body Mounts

Tie Rods

Edelbrock Tie Rod Links

Ball Joints

Front & Rear Control Arm Bushing

Rear Control Arms Blocked for Added Strength

Hotchkis Rear Stabilizer Bar

Front Wheel Bearings

Front & Rear Coil Springs

Monroe Front Shock Absorbers

Gabriel Load Carrier Rear Shock Absorbers

MOOG Front Stabilizer Bar Links

Fuel Gauge Sending Unit

Tail Light Lenses – Correct orientation for 1978 model year.

Front Air Dam / Body Skirt

Cowl Induction Hood – Steel

Hood Bumpers

Grille

Chrome ION 625 Wheels – 16 x 8

BF Goodrich G-Force Sport Tires – 225/50ZR-16

Door Locks

Tail Gate Cables

Interior:

Seat Upholstery

Seat Belts

Carpet

Headliner

Trim

Dash Overlay

Headlight Switch

Viper Alarm System

Prewired for AMP system

White Face Instrument Cluster

Factory Tachometer

Blue LED Instrument Cluster Back Lighting

Ignition Switch

Delay Courtesy Light Module

Sony AM/FM/CD/MP3/iPod Receiver

 

Engine Specifications

BLOCK:  SMALL BLOCK CHEVY 400 4 BOLT MAIN / HIGH NICKEL CONTENT (VERY HARD TO FIND)!!!!

HEADS: CHEVY LARGE VALVE HP CYLINDER HEADS (ALL NEW PARTS: VALVES, HP SPRINGS, GUIDES, RETAINERS, ROCKER STUDS, GUIDEPLATES)

CRANKSHAFT: CHEVROLET 400

MACHINE WORK:
Oven Baked & Magnifluxed (Completely Cleaned & Checked For Cracks)
Bored & Finished Computer Honed To Within .0002'' Straightness & Roundness
Align Honed Main Bearing Bores/Saddles
Square Decked
Re-Size Connecting Rods (GM 5.7" "PINK" FORGED)
3 Angle Competition Valve Job
Balanced & Blueprinted
PROFESSIONALLY Assembled


ALL NEW PARTS:
SPEED PRO FORGED HP PISTONS
Hastings Rings
Clevite CL-77 Rod/Main/Cam Bearings
CRANE Hydraulic Flat-tappet HP Camshaft (LIFT: .488" I / .510" E; DUR @ .050" 234 I / 244 E; LOBE SEPERATION: 112)
SA Gear Double Roller HP Timing Set
HP Connecting Rod Bolts (180,000 p.s.i)
GM Stemped Steel Rocker Arms (1:5 Ratio)
Fel-Pro Gasket Set
Melling HV Pump
Melling Oil Pump Pickup Screen
Melling Oil Pump Driveshaft
SSI/Specialty Products Oil Pan
Professional Products HP Harmonic Balancer
CHEVROLET Head Bolts
HP Valves
Manley HP Pushrods
Pioneer Brass Freeze Plugs
Dipstick & Tube Holder
Fasteners (Intake Manifold, Valve Covers, Oil Pan, Waterpump Bolts)


Horsepower: 430 (engine only)
Torque: 505 FT/LBS

If you have any questions please feel free to ask.

Thanks for looking and happy bidding!

All sales are final, no returns or refunds, item(s)/vehicles are as-is no warranty.  Payment must be made within 5 days for auction purchases; immediate payment is required on "Buy It Now" purchases.  Failure to follow suit will result in the item(s) being relisted and negative feedback will be left.  Serious bidders/buyers only please, if you are not interested do not submit a bid or purchase.  Please leave me positive feedback and I will do the same for you.

***** Buyer responsible to make arrangements to have the vehicle shipped or pick up locally. *****

Auto Services in Arizona

Tri-City Towing ★★★★★

Auto Repair & Service, Automotive Roadside Service, Towing
Address: 751 E Aspen St, Peeples-Valley
Phone: (866) 595-6470

T & R upholstery & Body Works ★★★★★

Automobile Body Repairing & Painting, Automobile Seat Covers, Tops & Upholstery, Draperies, Curtains & Window Treatments
Address: 3880 Andy Devine, Kingman
Phone: (928) 757-7700

Super Discount Transmissions ★★★★★

Auto Repair & Service, Auto Transmission
Address: 3220 E McDowell Rd, Phoenix
Phone: (602) 273-6431

Stamps Auto ★★★★★

Automobile Parts & Supplies, Automobile Accessories, Battery Supplies
Address: 9123 E Southern Ave, Apache-Jct
Phone: (480) 986-3602

Solar Ray Auto Glass Repair ★★★★★

Auto Repair & Service, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 3370 N Hayden Rd, Paradise-Valley
Phone: (480) 648-2022

Sierra Toyota ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 2596 E Fry Blvd, Sierra-Vista
Phone: (877) 245-9461

Auto blog

GM investing $167m in Spring Hill for new midsize vehicles

Tue, 06 Aug 2013

General Motors has announced a large investment in its Spring Hill, Tennessee facility. The former home of Saturn production will be getting a $167 million addition to a previously announced $183 million, to cover a pair of new midsize vehicles. The investment is expected to create 1,800 jobs at the factory.
That $350 million is being divvied up for a pair of programs at Spring Hill. The first will take the bulk of the money ($223 million) and create 1,000 of the 1,800 jobs, while the other will take the remaining $127 million and generate the leftover 800 positions. But GM says the investment will cover "midsize vehicle programs." So what could they be?
The leading candidate in our minds is a new crossover for Buick, called the Anthem, that will slot between the Encore and Enclave, but will be slightly smaller than the Equinox and Terrain. As we've explained, the new model will likely be the first product to sport GM's new D2UX platform, which will eventually replace both the Delta and Theta platforms. Spring Hill is already building the Equinox, so there could be some credence to this theory.

GM 6.2L V8 claims most powerful light-duty truck engine title

Thu, 12 Sep 2013

General Motors has officially captured the horsepower crown for mainstream pickup trucks with its 6.2-liter V8. The big mill, available in both the Chevrolet Silverado and GMC Sierra, comes to market with 420 horsepower and 460 pound-feet of torque, handily outdoing its two cross-town competitors, Ram (5.7-liter V8, 395 ponies and 407 lb-ft) and Ford (6.2-liter V8, 411 hp and 434 lb-ft).
The new GM 6.2 will take a bit of an investment, though. Those that want the extra thrust will need to go with either the LTZ or High Country trims from the Chevy, or the SLT and Denali trims from GMC, which are the two highest trim levels for the respective vehicles. Trim levels aside, if you're in the business of towing, GM has you covered. Optioned with the 6.2-liter V8 and the Max Trailering Package, owners will be able to pull 12,000 pounds, a hugely impressive figure.
We still aren't certain as to what sort of economy the new engine will get, but it'll probably be a bad bet for the fuel conscious. As for availability, expect to see the 6.2-liter trucks in showrooms later in the fall.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

Mon, 04 Feb 2013

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.